Version 5.5 > SSP and PowerPoint
1/17/2006 4:34:45 AM
We use the SSP PowerPoint support all the time, with one
exception. I have noticed that when running an
automatically-timed PPT slideshow through SSP the timings are all off,
usually by a noticeable amount. As a result, those few times when
we run programmed/timed PPT shows we must run then externally rather
than from within SSP, and this causes operator issues except among our
most skilled and experienced operators.
Is there any way to fix this issue, or a workaround? Will it be fixed in v7 when it comes out?
Thanks,
Roger
Is there any way to fix this issue, or a workaround? Will it be fixed in v7 when it comes out?
Thanks,
Roger
1/17/2006 4:53:44 AM
Do you have the promodule set for SSP control or PPT control?
We've had much better luck with PPT control.
We've had much better luck with PPT control.
1/22/2006 6:28:07 PM
Haven't tried that yet, because we often have stability problems with
SSP when we enable PPT control. But I will test it as soon as
possible. Wouldn't surprise me if it resolves the issue, but I
don't necessarily like the solution if it means having to use PPT
control a lot.
1/22/2006 8:43:12 PM
I've never had good luck with the SSP control of the PPT, so I always have PPT control enabled.
1/24/2006 4:20:58 PM
SSP control is the way we do it also.
1/24/2006 4:21:32 PM
Whoooooooops, I mean PPT control, sorry long day.
To post messages to the forums you must be signed in to a user account.