Version 8.0 > Page-by-Page vs Verse-by-Verse
5/11/2014 7:13:46 AM
We have had Page-by-Page as the default setting early in V7, and have used it ever since.
Ever since using V8, every time we load the program, it reverts back to Verse-by-Verse. Is it because we have not pulled the trigger and converted the files to be version 8? (When we are asked if we are still using V7, we say that we are, thus keeping the settings from being completely converted to V8). Or is there something else terrible afoot?
Ever since using V8, every time we load the program, it reverts back to Verse-by-Verse. Is it because we have not pulled the trigger and converted the files to be version 8? (When we are asked if we are still using V7, we say that we are, thus keeping the settings from being completely converted to V8). Or is there something else terrible afoot?
5/13/2014 12:41:24 PM
Jeff,
The message you are seeing does not indicate that files will be converted - there is no specific conversion of files for Version 8.
The solution will be to select no and proceed. This will allow version 8 to properly save the slide properties that you are trying to set.
Check this KB (TS250) for additional details.
The message you are seeing does not indicate that files will be converted - there is no specific conversion of files for Version 8.
The solution will be to select no and proceed. This will allow version 8 to properly save the slide properties that you are trying to set.
Check this KB (TS250) for additional details.
To post messages to the forums you must be signed in to a user account.